Armac Martin - Digbeth Offset Latch (3/8 inch Door)

Armac Martin - Digbeth Offset Latch (3/8 inch Door)

DIG/LATCH/OFFSET/55/AGC

Armac Martin has machined solid brass hardware in Birmingham, England for four generations, hand polishing and finishing every piece across a suite of living, lacquered, and plated finishes. It is among the most exacting brass houses in the trade. Banbury Lane carries one of the most comprehensive Armac Martin displays in Canada. Hand the hardware to a client, weigh one collection against another, compare two finishes under showroom lighting before committing to spec. Finish chips are sent to the design office or job site on request. Specified through Banbury Lane, shipped across Canada.

The Digbeth Offset Latch is a square-section cabinet latch from the Digbeth collection, a cuboid form with crisp edges and an industrial, design-led line, named for its bold Birmingham district. This is the Ridged, linear-textured version. The offset body is sized to suit a 3/8 inch (10mm) door.

Machined from solid brass in Birmingham, England, the Digbeth sits in Armac Martin's Luxe tier. The latch coordinates with the Digbeth pulls and knobs for a consistent program across cabinetry.

Available across Armac Martin's finish range, from plated and lacquered options that hold their tone to hand-burnished and unlacquered brass that are living finishes by design, developing patina with use. No finish warranty is offered on the living finishes. The patina is the design intent, not a defect.


Aged Copper AGCliving finish

Machined from solid brass, hand sateened to a brushed satin ground, then plated in copper and drawn through an antiquing solution before barrelling to bring up the aged tone. A living finish: the surface continues to deepen and darken with handling and time.

A living finish. Left unlacquered, it will patinate and darken with use. Clean with a soft dry cloth; avoid abrasives and chemical polishes, which cut the developing patina.

Finish 19 finishes
Finish
Overall Length
81mm
Projection
30mm
Width / Diameter
55mm

Lead Time

Made to order by Armac Martin. Approximately 2 to 4 weeks to our Calgary showroom.

When to Specify

Specified for inset cabinet doors where a concealed offset latch is wanted with Digbeth cabinetry.

Configuration Note

Supplied as an offset latch body with strike, sized to suit a 3/8 inch (10mm) door. Mounts to the door and frame.


Vu récemment