Armac Martin - Digbeth Pull With Back Plate
DIG/128/BEL
Armac Martin has machined solid brass hardware in Birmingham, England for four generations, hand polishing and finishing every piece across a suite of living, lacquered, and plated finishes. It is among the most exacting brass houses in the trade. Banbury Lane carries one of the most comprehensive Armac Martin displays in Canada. Hand the hardware to a client, weigh one collection against another, compare two finishes under showroom lighting before committing to spec. Finish chips are sent to the design office or job site on request. Specified through Banbury Lane, shipped across Canada.
The Digbeth Pull is a square-section cuboid bar with crisp edges and an industrial line, here grounded on a coordinating backplate, machined from solid brass in Birmingham, England. Specified through Banbury Lane for kitchen, bath, and furniture-grade cabinetry where hardware reads as a deliberate material choice rather than a fitting.
Machined from solid brass, hand sateened to a brushed satin, then given a light antique patina before barrelling. Living finish; the surface oxidises and patinas with age and handling.
Living finish. Expect natural darkening and patina with age and handling. Clean with a soft dry cloth. To brighten, polish or wax; no lacquer is applied.
- Center to Center
- 128mm
- Projection
- 37mm
Lead Time
Made to order by Armac Martin. Approximately 2 to 4 weeks to our Calgary showroom.
When to Specify
Specified for contemporary cabinetry where a squared, industrial pull with surface detail is wanted as a grounded, backplated statement.
Configuration Note
Supplied as a single handle on its backplate. Order one per drawer or door front. Fixing centres are listed by size in the specification table. A post-fixed Digbeth is available separately.